Important Spray gun settings

technique.

Moderator: Hub

Important Spray gun settings

Postby Hub » Sun Nov 24, 2019 4:31 am

Hello Verna REA; Starter settings for your LPH 400 / with a 1.4 fluid tip and a LVX air cap THIS combination requires an inlet pressure of 16 PSI @ the gun with full open settings on the air valve in the handle , material valve and the fan control valve , all in the full open position and with the trigger pulled to the full back position and WITH air passing through the gun for at least 2 minutes IF THE INLET PRESSURE STAYS AT THE REQUIRED 16 PSI @ THE GUN YOU ARE GOOD TO GO -- AT THIS POINT YOU KNOW YOU HAVE ENOUGH AIR SO YOU ARE GOOD TO GO WITH ANY FINE TUNING : :P
Cheers HUB
User avatar
Hub
Air Authority
 
Posts: 2602
Joined: Thu Jan 06, 2005 7:50 pm

Return to Spraying

Who is online

Users browsing this forum: No registered users and 2 guests

cron