LPH80 settings?

[IMCustom]

I'm Ian, airbrush artist. I was recommended the LPH80 E2 by someone. It seems everyone actually has the E4, which I didn't know! Anyway, I bought the LPH80 1.2 with the E2 and was playing with a bit last night and wasn't really getting a good spray out of it.. HoK 2:1 BC25, was blowing at the recommended 13 psi, played with the fan/flow for awhile but couldn't seem to get it flowing smooth.

Suggestions, or initial settings I should try?

Thanks

[IMCustom]

Played around with it all night, and finally sprayed a smooth panel with it. I will say one thing, I wish it had a bigger fan pattern for sure. Is it possible to get the E4 tip and just put it on?

[Hub]

Played around with it all night, and finally sprayed a smooth panel with it. I will say one thing, I wish it had a bigger fan pattern for sure. Is it possible to get the E4 tip and just put it on?

An E4 air cap (pn 93662600) will answer all your prayers - The combination of the 1.2mm fluid nozzle and the E4 air cap - will give you a spray pattern size range from pin point to a full 5.5 - 6 inch wide wet line spray pattern. Yep, a quick and easy installation - just screw off the E2 and screw on the E4
Cheers,
"HUB"